Study on Water Modeling for Optimizing Flow Control Device in Tundish for Three-strand Bloom Casting
-
摘要: 针对中间包夹杂物超标的问题,采用1∶2的水力学模型,对三流320 mm×480 mm大方坯中间包流场进行物理模拟,研究控流装置对钢液流动特性的影响,优化中间包流场。模拟结果表明:原型中间包存在着滞止时间短、死区比例大、持续流动的液体对中间包前壁不断的冲刷侵蚀的问题。采用方案3的挡墙与挡坝,滞止时间增加了18.05 s,且两个水口的滞止时间标准差仅为0.18,死区比例降幅为30.51%,很好地改善了液体的流动特性。Abstract: In view of excessive non-metallic inclusion content in a three-strand tundish for 320 mm×480 mm bloom casting,the effect of flow control device on flow characteristics of the tundish has been studied by water modeling with a geometrical similarity ratio 1:2 to optimize the tundish flow field.The results reveal the problems with the prototype tundish such as short residence time,large dead zone and erosion in the front wall of tundish by continuous flow of molten steel.The residence time is increased by 18.05 s while standard deviation of residence time Stmin between the two nozzles is only at 0.18 and the dead zone is decreased by 30.15% by using the baffle and dam in scheme 3,which greatly improves the flow characteristic of liquid.
-
Key words:
- tundish /
- flow field /
- water modeling /
- baffle /
- dam
点击查看大图
计量
- 文章访问数: 21
- HTML全文浏览量: 9
- PDF下载量: 1
- 被引次数: 0