留言板

尊敬的读者、作者、审稿人, 关于本刊的投稿、审稿、编辑和出版的任何问题, 您可以本页添加留言。我们将尽快给您答复。谢谢您的支持!

姓名
邮箱
手机号码
标题
留言内容
验证码

高铝增强成形性双相钢980DH组织性能研究

周莉 薛仁杰 曹晓恩 董梦瑶

周莉, 薛仁杰, 曹晓恩, 董梦瑶. 高铝增强成形性双相钢980DH组织性能研究[J]. 钢铁钒钛, 2022, 43(2): 186-191. doi: 10.7513/j.issn.1004-7638.2022.02.028
引用本文: 周莉, 薛仁杰, 曹晓恩, 董梦瑶. 高铝增强成形性双相钢980DH组织性能研究[J]. 钢铁钒钛, 2022, 43(2): 186-191. doi: 10.7513/j.issn.1004-7638.2022.02.028
Zhou Li, Xue Renjie, Cao Xiao’en, Dong Mengyao. Study on microstructure and properties of high aluminum dual phase steel 980DH with high formability[J]. IRON STEEL VANADIUM TITANIUM, 2022, 43(2): 186-191. doi: 10.7513/j.issn.1004-7638.2022.02.028
Citation: Zhou Li, Xue Renjie, Cao Xiao’en, Dong Mengyao. Study on microstructure and properties of high aluminum dual phase steel 980DH with high formability[J]. IRON STEEL VANADIUM TITANIUM, 2022, 43(2): 186-191. doi: 10.7513/j.issn.1004-7638.2022.02.028

高铝增强成形性双相钢980DH组织性能研究

doi: 10.7513/j.issn.1004-7638.2022.02.028
基金项目: 重庆市教委科学技术研究项目(编号 :KJ1730416)。
详细信息
    作者简介:

    周莉(1989—),女,讲师,硕士,主要从事金属材料研究,E-mail:zhouli89@yeah.net

    通讯作者:

    曹晓恩(1986—),男,高级工程师,博士,主要从事汽车板产品研发及材料成型工艺研究,E-mail:caoxiaoen1986@163.com

  • 中图分类号: TF76,TG142.1

Study on microstructure and properties of high aluminum dual phase steel 980DH with high formability

  • 摘要: 采用相变淬火膨胀仪、连退热模拟试验机等开展高铝增强成形性双相钢980DH静态连续冷却转变、连续退火工艺对冷轧板组织、性能的影响规律研究。结果显示:冷却速率在5~10 ℃/s,只发生贝氏体相变;当冷速>15 ℃/s后,随着冷速的提高,贝氏体占比减少,马氏体含量增加;980DH钢基体组织主要为铁素体、马氏体和残余奥氏体;均热温度(780~800 ℃)×160 s、缓冷温度650~700 ℃、冷却速率50 ℃/s快冷至300 ℃,保温5 min时效处理后空冷至室温,可获得性能优异的CR550/980DH。研究结果对工业开发高级别DH钢具有指导意义。
  • 图  1  静态连续冷却工艺示意

    Figure  1.  Schematic diagram of static continuous cooling process

    图  2  温度-膨胀量曲线

    Figure  2.  Curve of temperature-expansion of tested steel

    图  3  静态CCT曲线

    Figure  3.  Static CCT curve of tested steel

    图  4  不同冷速条件下显微组织

    Figure  4.  Microstructure of steel cooled down at different cooling rates

    图  5  连退热模拟试验钢显微组织

    (a)方案1;(b)方案2;(c)方案3;(d)方案4;(e)方案5;(f)方案6

    Figure  5.  Microstructure of steel after continuous annealing simulation experiment

    图  6  方案5试验钢的EBSD形貌

    Figure  6.  EBSD morphology of experimental steel in scheme 5

    表  1  试验钢980DH主要化学成分

    Table  1.   Main chemical compositions of experimental steel 980DH %

    CSiMnPSAlsNbTiCrMo
    0.120.402.00.0120.0080.550.0250.0150.250.20
    下载: 导出CSV

    表  2  试验方案及力学性能

    Table  2.   Experimental scheme and mechanical properties

    方案均热温度/℃缓冷温度/℃快冷温度/℃Rp0.2/MPaRm/MPaA/%
    1820700300606106214.51
    2800700300561103416.41
    3780700300638107516.45
    4800680300581.71027.516.03
    5800650300579.71038.816.41
    68007203006041046.514.96
    下载: 导出CSV
  • [1] 唐荻, 赵征志, 米振莉, 等. 汽车用先进高强板带钢[M]. 北京: 冶金工业出版社, 2016.

    Tang Di, Zhao Zhengzhi, Mi Zhenli, et al. Advanced high strength strip steel for automobile[M]. Beijing: Metallurgical Industry Press, 2016.
    [2] Kang Yonglin. Light weight vehicle, advanced high strength steel and energy-saving and emission reduction[J]. Iron and Steel, 2008,43(6):1−7. (康永林. 汽车轻量化先进高强钢与节能减排[J]. 钢铁, 2008,43(6):1−7. doi: 10.3321/j.issn:0449-749X.2008.06.001
    [3] 康永林. 现代汽车板工艺及成形理论与技术[M]. 北京: 冶金工业出版社, 2009.

    Kang Yonglin. Theory and technolog of processing and forming for advanced automobile steel sheets[M]. Beijing: Metallurgical Industry Press, 2009.
    [4] Liang Jiangtao, Zhao Zhengzhi, Liu Kun, et al. Microstructure and properties of 1300 MPa grade Nb microalloying DH steel[J]. Chinese Journal of Engineering, 2021,43(3):392−399. (梁江涛, 赵征志, 刘锟, 等. 1300 MPa级Nb微合金化DH钢的组织性能[J]. 工程科学学报, 2021,43(3):392−399.
    [5] 张伟, 李春光, 林兴明, 等. 基于压溃试验增强成形性双相钢吸能特性分析[C]//第十二届中国钢铁年会论文集—5. 金属材料深加工. 中国金属学会, 2019: 7.

    Zhang Wei, Li Chunguang, Lin Xingming, et al. Analysis of energy absorption characteristics of dual phase steel with high formability based on drop test[C]// Proceedings of the 12th China Iron and Steel Annual Conference – 5: Deep Processing of Metal Materials. Chinese Society of Metals, 2019: 7.
    [6] Lu Lin, Tang Di, Jiang Haitao. Microstructure and properties of high aluminum 1000 MPa cold rolling hot dip galvanized dual phase steel[J]. Transactions of Materials and Heat Treatment, 2015,36(4):116−120. (卢淋, 唐荻, 江海涛. 高铝1000 MPa级热镀锌双相钢的组织和性能[J]. 材料热处理学报, 2015,36(4):116−120.
    [7] Wang Xiaojie. Study on surface longitudinal crack of W780QX slab[J]. Hebei Metallurgy, 2020,(4):49−52. (王肖杰. 高铝双相钢W780QX板坯表面纵裂研究[J]. 河北冶金, 2020,(4):49−52.
    [8] Wang Chang, Yu Yang, Gao Xiaoli, et al. Oxidation characteristic of high aluminum bearing double phase steel[J]. China Metallurgy, 2016,26(9):23−27. (王畅, 于洋, 高小丽, 等. 高铝双相钢氧化特性规律[J]. 中国冶金, 2016,26(9):23−27.
    [9] Wang Hui, Deng Zhaojun, Lin Chengjiang, et al. Effect of temper-aging temperature on the microstructures and properties of the annealed high aluminum dual phase steel[J]. Rare Metal Materials and Engineering, 2011,40(S2):184−187. (王辉, 邓照军, 林承江, 等. 连退时效温度对高铝双相钢组织及性能的影响[J]. 稀有金属材料与工程, 2011,40(S2):184−187.
    [10] Deng Zhaojun, Liu Jing, Wang Hui, et al. Influence of annealing temperature on microstructure of a high aluminum dual phase steel[J]. Transactions of Materials and Heat Treatment, 2011,32(3):111−114. (邓照军, 刘静, 王辉, 等. 退火温度对高铝双相钢微观组织的影响[J]. 材料热处理学报, 2011,32(3):111−114.
  • 加载中
图(6) / 表(2)
计量
  • 文章访问数:  115
  • HTML全文浏览量:  15
  • PDF下载量:  22
  • 被引次数: 0
出版历程
  • 收稿日期:  2021-05-23
  • 网络出版日期:  2022-05-11
  • 刊出日期:  2022-04-28

目录

    /

    返回文章
    返回