温度对连铸结晶器保护渣黏度和热流密度的影响

留言板

尊敬的读者、作者、审稿人, 关于本刊的投稿、审稿、编辑和出版的任何问题, 您可以本页添加留言。我们将尽快给您答复。谢谢您的支持!

姓名

邮箱

手机号码

标题

留言内容

验证码

基金项目:

国家自然科学基金资助项目 (51174073, U1360106)；河北省教育厅资助项目 (QN20131013)

Study on Viscosity and Heat Flux Density of Casting Mold Powder at Different Temperature

1. College of Mining Engineering, Hebei United University, Tangshan 063009, Hebei, China;
2. Mining Development and Safety Technology Key Lab of Hebei Province, Tangshan 063009, Hebei, China

摘要: 炼钢连铸过程中结晶器保护渣的黏度、热流密度会对铸坯质量产生较大影响,采用结晶器渣膜热流模拟和黏度测试仪,研究了唐钢二钢轧厂低、中碳钢连铸用保护渣在不同温度下的黏度和热流密度。结果表明,在1 200~1 400℃温度范围内,随着熔渣温度的升高,低、中碳钢保护渣黏度值均呈现急剧下降的趋势,在温度超过1 350℃后,黏度下降幅度趋于平缓;与黏度变化相比,热流密度随温度的升高却呈现增大的趋势,并且在温度升高到1 250℃时,增大的幅度就开始趋于平缓。
- 连铸 /
- 保护渣 /
- 黏度 /
- 热流密度 /
- 润滑 /
- 传热
Abstract: The viscosity and heat flux density of mold fluxes have a great impact on the quality of slab via continuous casting.Different casting mold powders used for low and medium carbon steels had been studied in term of their viscosity and heat flux density of at diferent temperatures through heat flux simulation and viscosity meter.The results show that with increasing temperature in 1 200~1 400℃,the viscositiy of mold powders for low-carbon and medium-carbon steels casting dramatically decreased until 1 350℃,however,the heat flux density of mold fluxes increased and its increment slowed down after temperature reaching 1 250℃.
- continuous casting /
- casting powder /
- viscosity /
- heat flux density /
- lubrication /
- heat transfer